| Specifications |
| Features |
Description |
| Frequency Range |
20Hz to 100kHz |
| Frequency Steps |
20Hz to
1kHz: 5Hz
1kHz to 10kHz: 50Hz
10kHz to 100kHz: 500Hz |
| AC Drive Level |
Open circuit: 0.25V, 0.5V, 1V &
2Vrms
Signal source impedance: 100Ω |
Measurement
parameters
DC Bias
Internal |
Impedance
Phase Angle
Capacitance
Quality Factor
AC Resistance
DC Resistance
Any combination |
Series/parallel
equivalent circuit |
Any
combination |
Measurement
Range |
Parameter |
Range |
| Z, R, X |
0.01mΩ to >1GΩ |
| L |
1nH to >2kH |
| C |
0.01pF to >1F |
| D, Q |
0.0001 to 9999.9 |
| Phase Angle |
-180° to +180° |
| Rdc |
0.1mΩ to >100MΩ |
| Basic Accuracy |
0.1%
Varies with speed,
frequency, AC drive level and impedance of Device Under Test |
Measurement
speeds |
Four selectable measurement
speeds for all functions. Up to 50 measurements per second,
depending on frequency and set up conditions. |
| Measurement Connections |
4 front panel BNC sockets with
screens at ground potential. |
Measurement
Modes |
Results for any two parameters
can be displayed with full setup details.
Scale Mode allows
results for both parameters to be shown on a bar graphs with
user defined high and low limits and PASS/FAIL indication. |
Measurement
Setup Memory |
20 different setups can be stored
and recalled from internal memory. |
| Power requirements |
90VAC to 264VAC (Autoranging);
47Hz to 63Hz |
| Display |
1/4 VGA (320 x 240) Black & White |
| Remote control |
RS-232 |
)
PDF
Help