| Signal Input
(Video and External
Reference) |
| Return Loss |
>40 dB, 50 kHz to 6 MHz, power on or off |
| Maximum Input |
±5 V DC + peak AC |
| Loop-through Isolation |
>80 dB at FSC |
| Channel Isolation |
>50 dB at FSC |
| Impedance |
>15 Ω |
| Vertical Deflection |
| Deflection Factor |
Within 1% of 1V |
| Gain Range |
Input signals between 0.8V and 2V can be adjusted to a 1V
display; (160 mV and 400mV for X5 gain) |
| Position Range |
1 V signal can be positioned so that peak white and sync
tip can be placed at blanking level regardless or gain range |
| Frequency Response |
| Flat |
50 kHz to 6 MHz within 2% (X1), within 5% (X5) |
| Low Pass |
40 dB attenuation at FSC; Low pass
response within 1% of flat response (1735: 30dB) |
| Chroma |
Nominal bandwidth 1 MHz; 2X FSC attenuation
>20 dB; Chroma response within 1% of flat response |
| Transient Response |
| Preshoot |
<1% |
| Overshoot |
<2% |
| Ringing |
<2% |
| Tilt |
<1% |
| Pulse-to-Bar Ratio |
0.99:1 to 1.01:1 |
| Differential Gain |
<1% |
| DC Restoration |
| Clamp Time |
Back Porch |
| Frequency Response |
Attenuation of 60 Hz on input signal |
| Slow Mode |
<20% |
| Fast Mode |
>90% |
| Blanking Level Shift |
A 10% to 90% APL change will cause <1% of blanking level shift. Presence or
absence of color burst will cause <1% of blanking shift |
| PIX Monitor Output |
| Frequency Response |
50kHz to 6 MHz within 3% |
| Differential Gain |
<1% |
| Differential Phase |
<1% |
| DC Level on Output |
<0.5V into 75Ω
load |
| Intensification (brightup) |
180 mV DC offset on select lines |
| Output Impedance |
75 Ω nominal |
| Return Loss |
>30 dB, 50 kHz to 6 MHz |
| Input to Output (PIX MON) Gain Ratio Luminance |
1:1 ±5% at 15 kHz |
| Calibrator |
| Frequency |
100 kHz ±0.1 kHz |
| Timing Accuracy |
10µs, ±0.01 µs |
| Amplitude |
1 V, ±1% |
| Horizontal Deflection System |
| Sweep |
Sweep will occur with or without input signal |
| 1-Line Repetition Rate |
Equal to applied line rate, magnification equals 0.2 ms/div |
| 2-Line Repetition Rate |
Equal to half applied line rate, magnification equals 1 ms/div |
| 2-Field Repetition Rate |
Equal to applied frame rate, magnification equals approximately X25 |
| Timing Accuracy |
1 ms/div: Within 2%
0.2 ms/div: Within 3% |
| Linearity |
Within 2% |
| Differential Linearity |
Within 2% |
| Sweep Magnification Registration |
Magnification occurs about the center of the screen |
| Position Range |
Any portion of a synchronized video sweep can be positioned in all sweep modes |
| Synchronization |
| Internal |
Composite video or black burst with sync ±6 dB of nominal |
| External |
Sync amplitude of 143 mV to 4V |
| Remote Sync |
2.0 to 5.0 V square wave or 4.0V comp sync (sync polarity can be internally inverted) |
| RGB/YRGB |
Repetition rate: field rate and line rate with magnification of X25 and X10,
respectively |
| Sweep Length |
3-Step (RGB): 3.4 to 4.2 divs.
4-Step (YRGB): 2.5 to 3.1 divs. |
