Hewlett Packard 3582A
Dual-Channel, Dynamic Signal Analyzer
0.02 Hz to 25.5 kHz Specifications

FREQUENCY
Range	0.02 Hz to 25.5 kHz
Spans	1 Hz to 25 kHz in a 1-2.5-5-10 sequence
Accuracy	± 0.003% of display center frequency
Resolution	0.4% of the frequency span for single channel or 0.8% of the frequency span for dual channels
AMPLITUDE
Display Modes
Log	10 dB/division or 2 dB/division
Linear	constant voltage/division
Measurement Range
Log	+30 dBV to -120 dBV noise floor
Linear	+30 V to 1µV noise floor
Dynamic Range	70 dB
DC response	adjustable to >40 dB below maximum input level
Accuracy
Accuracy at the Passband Center	± 0.5 dB
Flat top filter	+0, -0.1 dB
Hanning filter	+0, -1.5 dB
Uniform filter	+0, -4.0 dB
Note: Overall accuracy is the sum of the accuracy at the passband center plus the selected filter accuracy.
Resolution
Log	0.1 dB
Linear	3 digits
PHASE
Display Range	+200° to -200°
Accuracy	± 10°
Resolution	1°
TRANSFER FUNCTION
Measurement Range
Log	+160 dB full scale to -80 dB full scale
Linear	4 X 10⁸ full scale to 4 X 10^-8 full scale
Phase display range	+200 degrees to -200 degrees
INPUT
Impedance	10⁶Ω ± 5% shunted by <60 pF from input high to low (for less than 75% relative humidity)
Isolation	input low may be floated up to 30V
Coupling	switch selection of ac or dc coupling. The low frequency 3 dB roll off is <1 Hz.
Common Mode Rejection	>58 dB
GENERAL
Power Requirements	100, 120, 220 or 240 volts (+5%, -10%); 48-66 Hz; less than 150 VA
Dimensions
Size	425.5 W X 52.5 D X 188 mmH (16.75" X 21.75" X 7.4")
Weight	net, 24.5 kg (54 lb); shipping, 29 kg (63 lb)

3582A Product Page

Used Equipment Catalog

$20.00 Minimum on Total Order

Hewlett Packard 3582A Dual-Channel, Dynamic Signal Analyzer 0.02 Hz to 25.5 kHz Specifications

Hewlett Packard 3582A
Dual-Channel, Dynamic Signal Analyzer
0.02 Hz to 25.5 kHz Specifications