| Specifications |
| Function |
Description |
| Waveform (Output A) |
| Waveform types |
Sine, Square, Pulse, DC |
| Waveform length |
4 ~ 16000 points |
| Vertical resolution |
10 bits |
| Sampling rate |
180 MSa/s |
| Harmonic distortion |
≥50dBc (<1MHz), ≥40dBc (1MHz ~ 20MHz), ≥30dBc(20MHz ~ 40MHz) |
| Sine total distortion |
≤0.5% (20Hz ~ 200kHz) |
| Square |
Rise/fall edge time: ≤ 20ns, Overshoot: ≤10% |
| Square wave duty cycle |
0.1% ~ 99.99% |
| Frequency (Output A) |
| Frequency range |
40mHz ~ Max.frequency, resolution
40mHz
40uHz ~ 1KHz, resolution 40uHz |
| Square wave range |
40uHz ~ 20MHz |
| Amplitude (Output A) |
| Amplitude range |
2mVpp ~ 20Vpp, 40mHz ~ 10MHz (high impedance)
2mVpp ~ 10Vpp, 10MHz ~ 40MHz (high impedance)
2mVpp ~ 4Vpp, 40MHz ~ 60MHz (high impedance) |
| Resolution |
20mVpp (amplitude > 2V), 2mVpp (amplitude > 2V) |
| Accuracy |
± (1% + 2mVrms) (high impedance, RMS, frequency 1kHz) |
| Stability |
±0.5% / 3 hours |
| Flatness |
±5% (frequency of 1MHz or below), ±10% (frequency of 1MHz ~ 10MHz); ±20% (frequency of 10MHz ~ 60MHz) |
| Output impedance |
50Ω |
| Offset (Output A) |
| Offset range |
±10V (high impedance) |
| Resolution |
20mV |
| Accuracy |
±(1% + 20mV) |
| Sweep (Output A) |
| Type |
Linear sweep (frequency or amplitude) |
| Sweep range |
Free to set starting point and endpoint |
| Sweep step |
Higher than any figure of there solution |
| Sweep rate |
10 ms ~ 60ms/step |
| Sweep mode |
Linear, Log Up or Log Down, Single |
| Frequency Modulation (FM) (Output A) |
| Modulating signal |
Internal or External waveforms |
| Modulation deviation |
0% ~ 20% |
| Amplitude Modulation (AM)
(Output A) |
| Modulating signal |
Internal or External waveforms |
| Modulation deviation |
0% ~ 120% |
| FSK, ASK, PSK(Output A) |
| FSK |
Free to set carrier waveform frequency and hopping frequency |
| ASK |
Free to set carrier wave form amplitude and hopping amplitude |
| PSK |
Hopping phase: 0 ~ 360°, Max. resolution: 11.25° |
| Alternative rate |
10ms ~ 60s |
| BURST |
| Burst |
General |
Output B signal issued as a BURST output signal. |
Output B
frequency range |
40uHz ~ 1MHz |
| BURST frequency |
30mHz ~ 50kHz |
| BURST count |
1 ~ 65000 cycles |
| BURST mode |
Internal, External, Single |
| TTL output |
| Waveform characteristics |
Square wave, rise/fall time ≤20ns |
| Frequency characteristics |
40mHz ~ 1MHz same as CHA |
| Amplitude characteristics |
TTL and CMOS compatible, low <0.3V, high> 4V |
| Frequency Counter |
| Frequency range |
1Hz ~ 100MHz |
| Input signal amplitude |
100mVpp ~ 20Vpp |
| General Specifications |
| Power Source |
110V/220VAC, (1±10%), 50Hz (1±5%) |
| Power Consumption, Display |
< 30V, TFT LCD |
| Environmental |
Temperature: 0~40°C
humidity: < 80% |
| Dimension |
14.4" x 10.2" x 4.3" |
| Weight |
6.6lbs |
)
PDF Help