Test Equipment Depot Top Nav Bar
Test Equipment Depot - 800.517.8431 Free Ground Shipping Offer
<< UniSource Function Generators

Unisource AFG1020
20MHz DDS Arbitrary/Waveform Function Generator
with Built-in 100MHz frequency counter, DDS, 2-Channel,
3.5-inch TFT LCD display, & Sampling rate 100Msa/s

Click here for a larger image of the Unisource AFG1020 20MHz DDS Arbitrary/Waveform Function Generator!Click here for larger image
Unisource AFG1020 Shown
Product Information
Datasheet 183 KB PDF Datasheet
Manual 635 KB PDF Manual
PDF HelpPDF Help
  • Maximum output frequency: 20MHz
  • 3.5 inch TFT LCD display
  • Direct Digital Synthesis technology (DDS)
  • Sampling rate 100Msa/s, vertical resolution 8 bit, waveform length 1Kpts
  • Arbitrary waveform functions, up to 8 sets of users defined waveforms
  • Output waveforms: 32 built-in waveforms and 8 sets of user defined waveforms
  • 40 sets panel setting save & recall
  • Min. 1mV (50) waveform output with good stability
  • FM, FSK, ASK, and PSK modulations
  • Over voltage protection, over current protection, short circuit protection, reverse voltage protection
  • Numeric keyboard and rotary dial for data input
  • SMT technology production, high reliability
  • 100MHz frequency counter
  • RS-232 interface
 
Specifications
Function Description
Waveform (Output A)
Waveform types 40 types waveforms, including Sine, Square, Pulse and 8 sets of arbitrary waveforms
Waveform length 1024 points
Vertical resolution 8 bits
Sampling rate 100 MSa/s
Sine harmonic distortion ≥40dBc (<1MHz), ≥35dBc (1MHz ~ 20MHz)
Sine total distortion ≤1% (20Hz ~ 200kHz)
Square Rise/fall edge time: ≤ 35ns, Overshoot: ≤10%
Square wave duty cycle 1% ~ 99%
Frequency (Output A)
Frequency range Sine wave: 40mHz ~ Max. frequency
Other waveforms: 40mHz ~ 1MHz
Resolution 40mHz
Accuracy ± (50ppm + 40mHz)
Amplitude (Output A)
Amplitude range 2mVpp ~ 20Vpp, 40mHz ~ 10MHz (high impedance)
2mVpp ~ 15Vpp, 10MHz ~ 15MHz (high impedance)
2mVpp ~ 8Vpp, 15MHz ~ 20MHz (high impedance)
Resolution 20mVpp (amplitude > 2Vpp), 2mVpp (amplitude > 2Vpp)
Accuracy ± (1% + 2mVrms) (high impedance, RMS, frequency 1kHz)
Stability ±0.5% / 3 hours
Flatness ±5% (frequency of 10MHz or below), ±10% (frequency above 10 MHz)
Output impedance 50Ω
Offset (Output A)
Offset range ±10V (high impedance, attenuation 0dB)
Resolution & Accuracy 20mVdc, ±(1% + 20mVdc)
Sweep (Output A)
Type Linear sweep or frequency sweep
Sweep range Free to set starting point and endpoint
Sweep step Higher than any figure of there solution
Sweep rate 10 ms ~ 60ms/step
Sweep mode Linear, Log Up or Log Down, Single
Frequency Modulation (FM) (Output A)
Carrier signal Output A waveforms
Modulating signal & deviation Output B signal or External signal, 0% ~ 20%
Burst
Burst counts 1 ~ 65000 cycles
Burst mode Internal, External, Single
FSK, ASK, PSK(Output A)
FSK Free to set carrier waveform frequency and hopping frequency
ASK Free to set carrier wave form amplitude and hopping amplitude
PSK Hopping phase: 0 ~ 360°, Max. resolution: 1°
Alternative rate 10ms ~ 60s
Output B
Waveform General 40 types waveforms, including Sine, Square, Pulse and 8 sets of arbitrary waveforms
Length 1024 points
Sampling range 12.5Msa/s
Amplitude Resolution 8 bits
Square wave duty cycle 1% ~ 99%
Frequency Range Sine wave: 40 mHz ~ 1MHz
Other waveforms: 10mHz ~ 100kHz
Resolution 10mHz
Accuracy ±(50ppm + 10mHz)
Amplitude Range 50mVpp ~ 20Vpp (high impedance)
Resolution 20mVpp
Accuracy 50Ω
Burst Burst count 1 ~ 65000 cycles
Burst mode Internal, External, Single
TTL output
Waveform characteristics Square wave, rise/fall time ≤20ns
Frequency characteristics 40mHz ~ 1MHz
Amplitude characteristics TTL and CMOS compatible, low <0.3V, high> 4V
Frequency Counter
Frequency range 1Hz ~ 100MHz
Input signal amplitude 100mVpp ~ 20Vpp
General Specifications
Power Source 110V/220VAC, (1±10%), 50Hz (1±5%)
Power Consumption, Display < 30V, TFT LCD
Environmental Temperature:0~40°C
humidity:< 80%
Dimension 14.4" x 10.2" x 4.3",
Weight 6.6lbs
 
Ordering Information
Model Description Buy Now Price
AFG1020 Unisource AFG1020 20MHz DDS Arbitrary/Waveform Function Generator with Built-in 100MHz frequency counter, DDS, 2-Channel, 3.5-inch TFT LCD display, & Sampling rate 100Msa/s Buy Now $799.00
Included Accessories
  • 1 - Power Cord
  • 1 - Q9 Test Lead
  • 1 - Q9 BNC-Clip Test Lead
  • 1 - RS-232 Cable
  • 1 - RS-232 Software CD
  • 1 - Operation manual
Included
 

UniSource Catalog | UniSource Pricelist

$40.00 Minimum on Total Order