|
|
|
|||||
|
||||||
|
|
||||||
<<
GE Telaire C02/Temperature CatalogGE
Telaire Ventostat |
|
|
) GE Telaire 8008 Shown |
| The GE Telaire Ventostat CO2 sensor can be used with applications
using a duct mounted sensor enable one sensor to control one air
handling zone. Two sensor mounting configurations are available,
“in-duct” and "remote” duct mount. For in-duct, the sensor (8001B,8002B,
or 8102B) is mounted inside the duct. Remote duct mount enables the user
to mount the sensor (8007,8008 or 8009) remotely with use of the pitot
sampling tube. All in-duct sensors are compatible with accessory
enclosures. The Ventostat controller offers an SPDT relay (normally open
or closed) and can be custom-programmed to a specific measurement and
output range using the UIP software interface or on-board keypad
(display units). The Ventostat 8007 and 8008 CO2 Ventostat Sensor is made for use in commercial buildings in need of demand controlled ventilation. Pitot tube configuration allows for easy installation and easy access to sensor for maintenance. Display and keypad allows for sensor programming without software. User Interface Program (UIP) All Ventostat 8000 (except the 8009) series controllers can be connected to a PC using the UIP 2072 Windows® program. Simply connect to the sensor using the onboardRJ45 jack and you can adjust the output scaling, elevation adjustment, relay set point, relay dead-band, select linear or proportional exponential output, perform single-point or two-point calibration, and check ppm levels. Display units can also be adjusted using the keypad. |
| ABC Logic Self Calibration Program Ventostat CO2 controllers use the patented ABC (Automatic Background Calibration) Logic self-calibration system that virtually eliminates the need for manual calibration in applications where the indoor CO2 level drops to outside levels during unoccupied periods (e.g. during evening hours). ABC Logic is a special software routine in the sensor that remembers the background readings for 14 consecutive evenings and calculates if there is sensor drift, then corrects for it. ABC Logic will not work properly in applications where the space is unoccupied for less than four hours a day or where there are industrial sources of CO2 in the building, such as breweries or wineries. Fast One-Step Calibration The CO2 Sensors (except the 8009) feature a fast one-step calibration process should it ever be required. A zero calibration can be performed in less than fifteen minutes by flowing gas to the calibration port and activating the calibration routine. If drift occurs in the sensor, it usually affects the zero setting of the sensor only. If a two point calibration is desired, it can be performed using the UIP Program. Lifetime Calibration Guarantee Telaire is serious about minimizing maintenance so each sensor, comes with a lifetime calibration guarantee. If a Telaire 8000 sensor drifts out of calibration range, it can be sent back to Telaire for a free factory calibration. |
| Model |
Description |
Buy Online |
Price |
| 8007 | Telaire 8007 Ventostat CO2 Sensor Duct Mount (no display) |
 |
$338.87 |
| 8008 | Telaire 8008 Ventostat CO2 Sensor (with Display) |
|
$349.17 |
$20.00 Minimum on Total Order
Home Page | Test Equipment Catalog | Specials | Repair
We Buy Surplus | Ordering/Contact Info
____________________________________________________________
99 Washington Street, Melrose, MA 02176
781.665.1400 | 800.517.8431 | Fax: 781.665.0780 | Email:
Copyright © Fotronic Corporation All Rights Reserved
PDF Help