This site uses cookies to provide an optimized shopping experience. By using this site, you agree the use of cookies within our privacy policy.
Telaire 8001
Ventostat CO2 Sensor (No Display) - Wall Mount
- Patented Absorption Infrared/Gas sensing engine provides high accuracy in a compact low cost package
- Patented ABC Logic self-calibration system eliminates the need for manual calibration in most applications
- Mounting bracket with terminal block provides quick, easy wiring
- Gas permeable, water resistant diffusion filter prevents particulate and water contamination of the sensor
- Patented Absorption Infrared/Gas sensing engine provides high accuracy in a compact low cost package
- Patented ABC Logic self-calibration system eliminates the need for manual calibration in most applications
- Mounting bracket with terminal block provides quick, easy wiring
- Gas permeable, water resistant diffusion filter prevents particulate and water contamination of the sensor
- Locking screw secures cover and sensor to the mounting bracket for tamper resistance
- Dual simultaneous analog output (V & mA)
- On board relay with adjustable set point and dead-band
- Choice of nine pre-programmed “standard settings” on easy-to-use interface
- PC interface and adjustable settings allow for simple configuration
- Optional enclosures available
- Conformal coated electronics
- Measures 0-2,000 PPM
- Power requirements 18-30VAC RMS
- Thirteen minute one-step calibration process.
- Lifetime calibration guarantee
The GE Telaire 8001 and 8002 Ventostat CO2 sensor are used as Wall mount sensors are used to control a specific area suchas a conference room, classroom, meeting hall, etc. Even though the sensors are designed for wall mount configurations, some sensors can also be configured for “in-duct” mount. For in-duct, the sensor (8001B, 8002B, and8102B) is mounted inside the duct to control an entire air-handling zone. All wall mount sensors (except the 8003)are compatible with accessory enclosures. The Ventostat controller offers a SPDT relay (normally open or closed) and can be custom programmed to a specific measurement and output range using the UIP software interface or on-board keypad (display units
The Ventostat 8001B and 8002B CO2 are for use in commercial buildings for demand controlled ventilation. The sensor can also be used as a wall mount. Conformal coated electronics and a high temperature enclosure (UL94-5 V) allow installation in harsh environments. Model 8002B includes a display and a keypad for sensor programming without software.
Brand | Telaire |
---|---|
Condition | NEW |
Vendor Alias | 8001 |
- 1 - Telaire 8001 Ventostat CO2 Sensor