Seaward DP6
Thermocouple Calibrator

  • Range: 10 mV - 1 V
  • Max Display: ± 15.000 mV - ± 1.5000 V
  • Resolution: 1 μV - 100 μV
  • Temperature coefficient: Typically 17 ppm/° C + 0.2 μV/° C
  • Deviation: 0.01 °C/ °C over the range 0 oto +50 ° C
  • Battery Type: 6 Volt, 1.2 Ah sealed lead acid, replaceable
  • Terminals: Two 4 mm low thermal emf copper terminals for measurement and injection.
Click for larger image of the Seaward DP6 Thermocouple CalibratorClick for larger image
Seaward DP6 Shown
Product Information
Datasheet 219 KB PDF
Manual 2.05 MB PDF
PDF HelpPDF Help

The Seaward DP6 is delivered complete with battery charger and comes fully charged ready for use. Before operating, read these instructions carefully. They will guide you through the operation and help you to get the best possible results.

After unpacking, inspect for physical damage and immediately report any defects in writing, retaining packaging materials for inspection.

The DP6 is a highly accurate portable calibrator designed for the measurement of the outputs from the thermocouples and all mV transducers as well as the simulation of thermocouples and mV signals.

The right hand to-line alphanumeric display shows the instrument status and programming options. The left hand display is a 4-1/2 digit LCD which indicated the measured or sourced value. The sealed switch membrane which forms the front panel, incorporates all the function keys necessary for configuration.

The plug top charger supplied with the instrument is a two-stage charger and can therefore be used for bulk and float charging. Safety circuits built into the DP6 ensure that the lead acid battery cannot be discharged below a pre-set value. This ensures that the maximum battery life will be achieved.

Ordering Information
Model Description Buy Now Price
DP6 Seaward DP6 Thermocouple Calibrator Discontinued
Included Accessories
  • 1 - Thermocouple calibrator
  • 1 - User manual