Rohde & Schwarz NAS
Directional Power Meter
Discontinued
Call for Refurbished Availability or Alternative Product Selection

• Two moving-coil meters
• Autoranging
• Battery operation
• Automatic switch off
• High EMI immunity
• Excellent price/performance ratio

Rohde & Schwarz NAS Shown

Product Information
Datasheet	356 KB
Ordering Info
PDF Help

Insertion units

Insertion units are either plugged to the side of the NAS or connected via a 1.5 m long cable for measurements at test points that are difficult to reach. Each insertion unit contains its individual calibration data which are read by the NAS and considered in the measurement results.

GSM900/1800/1900 applications
Insertion Units NAS-Z6 and NAS-Z7 measure the peak envelope power (PEP) of the clocked signal with due consideration of the timing laid down in the GSM specifications. The insertion units are ideal for measurements on mobile stations which according to definition are sending signals in only one of the eight timeslots. Transient overshoots of the signal bursts are eliminated by a signal-controlled circuit so that the forward and reflected power as well as the SWR can be correctly measured and indicated.

Standard applications
The standard Insertion Unit NAS-Z5 with its wide frequency range is suitable for almost any application and practically covers all commercial analog RT services including air navigation.

Shortwave applications
Insertion Units NAS-Z1 and NAS-Z2 have been especially designed for the frequency range up to 30 MHz. NAS-Z2 is for powers up to 1200 W for use in long-range shortwave communication systems.

Terminated power measurements
For measurements on transmitters, a Termination NAZ10 or NAZ30 acting as a dummy antenna is connected to the output of the insertion unit.