This site uses cookies to provide an optimized shopping experience. By using this site, you agree the use of cookies within our privacy policy.
psiber CTK1015
CableTracker Network ID Kit for Identifying the Cable Termination Point
CTK1015
CTK1015
- The RJ-45 male connection and the alligator clips are detachable and commonly available, meaning cord failure won't obsolete your tester
- Auto power down extends battery life and a built-in low battery indicator warns when battery replacement is required, saving unexpected down-time searching for batteries
- Test both active and inactive (dark) cables
- Two selectable tone frequencies and patterns allow multiple technicians to work on a network at the same time
- Three selectable port ID blink rates for the widest compatibility with LAN equipment (Blinks @ rate of transmitted signal)
- Detects short or open circuits
- Connection choice - Banana Plug to alligator clip (two) or RJ-45 Patch Cable
- Low battery indicator - Signal generator
- Non-conductive probe tip
- Power "On" indicator - Probe
- Volume Control
- Ergonomically designed
Operation:
- The easy to use CableTracker 10 signal generator steps through the operating modes with each press of the TEST button in the following sequence:
- Low Frequency Tone Pattern 1
- Low Frequency Tone Pattern 2
- High Frequency Tone Pattern 1
- High Frequency Tone Pattern 2
- Link Light Pattern 1
- Link Light Pattern 2
- Link Light Pattern 3
- Short Circuit Detection
- Off
The Cable Tracker Network Tone and Probe Kit model CTK1015 is designed for network managers and technicians. Toning an active LAN circuit can disrupt network traffic and is difficult to track due to cable twist and tone bleed. The Cable Tracker Network Tone and Probe Kit features a Port ID function that blinks the link light verifying cable connectivity. This feature also provides a simple and effective method to identify switch or hub port assignments on active networks. Three different blink rates are provided to ensure compatibility with equipment from a wide range of manufacturers. Traditional toning with two different tone frequencies and patterns is provided for non-active circuit tracing. Cable Tracker incorporates 3 link light activation speeds to easily identify user cable termination ports by simply looking for the blinking lights. Why three? Because Ethernet switches do not react the same to activation. Three speeds ensures the widest compatibility available.
| Country of Origin | United States |
|---|---|
| Brand | psiber |
| Condition | NEW |
| UPC | 850019910063 |
| Vendor Alias | CTK1015 |
- 1 - CT15 CableTracker
- 1 - CT10 CableTracker
- 1 - RJ-45 Patch Cable
- 1 - Banana Plug to Alligator Clip Leads (Black)
- 1 - Banana Plug to Alligator Clip Leads (Red)
- 2 - 9V Batteries
- 1 - Carrying Case
- 1 - User Manual
