Test Equipment Depot - 800.517.8431 McAfee Secure sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams
Test Equipment Catalog Specials Repair Surplus Ordering/Contact Info

<< PIE Loop Calibrators

PIE 334Plus
4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor
 
  • Calibrate Milliamp Instruments
    • Source: 0.000 to 24.000 mA & -25.00 to 125.00% of 4-20 mA
    • Read: 0.000 to 52.000 mA, -99.99 to 99.99 V
    • Simulate: 2-Wire Transmitters, Power & Read 2-Wire Transmitters
  • Selectable: 250 W resistor for HART compatibility
  • Calibrate with confidence
  • Accurate to ±0.025% of Span at 4.000 & 20.000 EZ-CHECK outputs
  • Easy-to-Read Display
  • Turn on the backlight to read in dark areas of the plant
  • Locate Loop Current Leakages
  • Measures ground current leakage from faulty wiring, flooded conduit and corrosion bridges.
  • Automatic indication of Loop Current and Leakage Current.
  • Faster Calibrations
  • Instantly select three outputs with EZ-CHECK switch Easily find trip points with two speed
  • EZ-DIAL plus Automatic Stepping & Ramping
 Click here for a larger image - PIE 334 4-20mA Loop Calibrator Click here for a larger image - PIE 334 4-20mA Loop Calibrator
PIE 334 Shown
Product Information
Datasheet 1.7 MB PDF
Click here for Information Regarding PDF'sPDF Help
 
The Piecal 334Plus 4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor builds on the Pie 334 with advanced features unique to PIE calibrators. Easily find current leaks to ground, deteriorating & damp insulation or corroded terminals with patented loop diagnostic technology. Automated stepping (2, 3 or 5 steps) and ramping lets you set the 334 Plus at one instrument and check any other point in the loop.

Get better calibrations with a five digit display to 20.000 mA. You can read the display in dim conditions with the built-in backlight. Additional improvements over 334 from other manufacturers include better long term stability, accuracy, reliability & ruggedness plus improved battery life.

PLUS the PIE 334-Plus exceeds the performance of many higher cost calibrators to meet today's most demanding requirements while maintaining the familiar, time proven reliability and ease of use of similar calibrators. The PIECAL 334Plus is the new milliamp calibrator standard
 
Specifications
Read mA
 Ranges 0.000 to 52.000 mA Full Span
Resolution -25.00 to 300.00% of 4-20 mA
Accuracy Below 24.01mA ≤ ± 0.05 % of 24.00mA (± 0.01mA)
Above 24.00mA ≤ ± 0.05 % of 52.00mA (± 0.02mA)
Voltage burden ≤ 2V at 50 mA
Overload/Current limit protection 54 mA nominal
Battery life ≥ 125 Hours nominal;
≥ 100 hrs with backlight on (334Plus)
Source/Power & Measure Two Wire Transmitters
 Ranges 0.000 to 24.000 mA Full Span
Resolution -25.00 to 125.00% of 4-20 mA
Accuracy EZ Check(s) at4
& 20mA		 ≤ ±0.025% of Span at 4 mA & 20 mA (± 0.005mA)
0.0 to 24.00 mA ≤ ± 0.05% of 24.00mA Span (± 0.01mA)
Noise ≤ ± ½ Least Significant Digit
Temperature effect ≤ ± 0.005 %/°C of FS
Loop compliance voltage ≥ 24 V DC @ 20.00mA
Loop drive capability 1200 Ω at 20 mA for 15 hours nominal; 950 Ω with Hart Resistor enabled
Battery life Source and Power measure mode ≥ 30 hrs at 12 mA nominal;
≥ 25 hrs with backlight on
2-Wire Transmitter Simulation
Accuracy Same as Source/Power & Measure
Voltage burden ≤ 2V at 20 mA
Overload/Current limit protection 24 mA nominal
Loop voltage limits 2 to 100 V DC (fuse-less protected from reverse polarity connections)
Battery life ≥ 125 hours nominal;
≥ 100 hrs with backlight on
Voltage Read
Range and Resolution -99.99 to +99.99 V DC Full Span (FS)
Accuracy ≤ ± 0.05 % of FS
Temperature effect ≤ ± 100 ppm/°C of FS
Input resistance ≥ 2 MΩ
Battery life ≥ 125 hours nominal;
≥ 100 hrs with backlight on
General
Temperature Range Operating -20 to 60 °C (-5 to 140 °F)
Storage -30 to 60 °C (-22 to 140 °F)
Relative Humidity Range  10 % ≤ RH ≤90 % (0 to 35 °C), Non-condensing
10 % ≤ RH ≤ 70 % (35 to 60 °C), Non-condensing
Size L=5.63 x W=3.00 x H=1.60 inches
Weight 12.1 ounces (including boot & batteries)
Batteries Four “AA” Alkaline 1.5V (LR6)
Low Battery Low battery indication with nominal 1 hour of operation left
Protection against misconnection Over-voltage protection to 135 V rms (rated for 30 seconds) or 240 V rms (rated for 15 seconds)
Display High contrast graphic liquid crystal display with 0.413” (10.5 mm) high digits
 
Ordering Information
Model Description Buy Online Price
334PLUS PIE 334Plus 4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor  Buy Now Sale $743.07
(Reg. $799.00)
334PLUSEW PIE 334PLUSEW 4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor with 6 year Extended Warranty  Buy Now Sale $929.07
(Reg. $999.00)
334PLUSRW PIE 334PLUSRW 4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor with 3 year Replacement Warranty  Buy Now Sale $929.07
(Reg. $999.00)
Included Accessories
 
  • 1 - Test Leads
  • 1 - NIST Calibration
  • 1 - Rubber Boot
 Included
Optional Accessories
0200100 PIE 020-0100 50Hz 6V 600mA AC Power Adaptor for models 530, 532, 334, & 334PLUS  Buy Now Sale $46.50
(Reg. $50.00)
0200101 PIE 020-0101 60Hz 6V 600mA AC Power Adaptor for models 530, 532, 334, & 334PLUS  Buy Now Sale $46.50
(Reg. $50.00)
0200103 PIE 020-0103 NiMh Charger with 4 "AA" Batteries (120V, 60Hz)  Buy Now Sale $55.80
(Reg. $60.00)
 

PIE Catalog   |   PIE Price List

$20.00 Minimum on Total Order

Home Page | Test Equipment Catalog | Specials | Repair
We Buy Surplus | Ordering/Contact Info
____________________________________________________________

99 Washington Street, Melrose, MA 02176
781.665.1400 | 800.517.8431 | Fax: 781.665.0780 | Email:

Copyright © Fotronic Corporation All Rights Reserved