|
Features |
|
Engineering Units (8-selectable) |
+0.025% FS or optional + 0.05% F.S. No temperature effect
from 23°to 122°F. |
|
Media Compatibility |
Non-isolated sensor for clean, dry, non-corrosive gases. |
|
Pressure Limits |
(DN) units |
3 x F.S. on high side only or 200 PSI, whichever is less. |
|
(GN or AN) units |
3 x F.S. range or 200 PSI, whichever is less. |
|
Accuracy |
No temperature effect over the entire operating range 14F° to 122°F (-10C° to +50°C). |
|
Temp. |
Displays the internal ambient temperature of the M1 in °C or °F. |
|
Record Mode |
The M1 can store up to 240 pressure measurements. |
Record Mode
Up to 240 pressure measurements |
Automatic |
The current value is automatically stored every 5 seconds, for up to 20 minutes. |
|
Manual |
The current value is stored every time the Units key is pressed, up to 240 times. |
|
Min/Max |
Displays the MIN and MAX
pressures |
|
Hold |
Freezes the pressure
measurement on the display, however, the bar graph is still
active. |
|
Ave |
Displays a continuous filtered
average of the pressure measurements. |
|
Backlight |
A green backlight is user activated via the backlight key.
A red backlight is automatically activated during an error/over range condition. |
|
Auto Shutoff |
To conserve battery life, the M1 will automatically power off after 20 minutes of keypad inactivity. |
|
Field Recalibration |
M1 can be calibrated in the field for zero and span. |
|
Low Battery Indication |
BAT icon is displayed when batteries require replacement.
Approximately 2 hours of run time is provided on a low battery condition. |
|
Bar Graph |
Horizontal bar for full scale pressure reference (0-100%) |
)
PDF Help