<< Megger Clampmeters

Megger DCM340
 600A, 600V AC/DC 400Hz Digital Clampmeter

• DC and AC current and voltage
• 600 A and 600 V
• Resistance and Continuity 3 ¾ digit, 4000 count display with Backlight
• High resolution digital bargraph
• Peak, Min/Max and Data-hold functions
• Zero-offset REL mode for comparative measurements
• Supplied complete with test leads and carry case
• IEC61010 CAT III 600 V

Megger DCM340 Shown

Product Information
Datasheet	69 KB
Ordering Info
PDF Help

There are four instruments in the family of high quality DCM300 series clamp meters from Megger, including the 400A AC. current-only DCM310; the DCM320 which includes voltage and resistance measurement; the DCM330 Fork-Multimeter, which is an open fixed-jaw design; and this, the DCM340. Capable of measuring AC and DC current up to 600A; AC and DC voltage up to 600V; resistance up to 400; and frequency up to 400Hz, the DCM340 is the most versatile in the range.

Current measurement combined with the comprehensive and accurate multimeter functions of the DCM340 eliminate the need to carry around both a clamp and multimeter – this instrument does it all.

The large clear digits of the numeric display are complimented by the high-resolution digital bar graph, useful for indicating trending and fluctuation of measurement. The backlight assists use in poorly lit areas such as distribution cupboards and corners of switchrooms; and the data-hold feature enables use on difficult access cables where otherwise the display may be impossible to see.

Min/Max hold provides the ability to store the maximum and minimum DC or rms values over a period of time. While storage is taking place, either the present, maximum or minimum value can be displayed. Peak hold stores the maximum and minimum peak value of an AC signal at a 10ms sample rate. The auto-off feature automatically places the meter in power-save mode after 30 minutes from power-on, but this can be disabled if required for min/max measurements.

Using the Relative mode (REL), a stable value can be stored, the instrument zeroed at that point, and then any variation from that value is displayed as a direct measurement relative to it.

The DCM340 is safety rated to IEC 61010-1 Cat III 600V, and is drop-tested to 1.2m onto a hard floor. It is supplied with test leads and a carry case, and a full 1-year manufacturers warranty.