- Compatible with a.c. and d.c. current clamps
- Energy monitoring mode (to calculate power, cumulative energy and cumulative cost)
- AC and DC millivolt measurement mode
- Logging rates between 1s and 12hr
- 4mm banana plug inputs
When the Lascar EL-USB-ACT is used with a current clamp, this standalone data logger measures and stores up to 127,232 a.c. and d.c. current readings over a 0 to 1000 amp d.c. measurement range (0 to 723 amps for a.c.). In energy monitoring mode, this data is converted into power, energy (using a user defined voltage value) and cost (using a user supplied energy unit cost). The millivolt measurement mode allows for direct measurement of voltage, up to 1V d.c. (700mV a.c.).
The user can easily set up the logger and view downloaded data by plugging the data logger into a PCs USB port and using the supplied software. The software has provision for a clamp scaling factor (the clamp input-output ratio of amps to millivolts). Stored data can then be graphed, printed and exported to other applications. The high contrast LCD can show a variety of current, power, energy and cost information. At the touch of a button, the user can cycle between the most recent, maximum and minimum measurement values. The data logger is fitted with 2 replaceable AA batteries.
|BATT 3V6||Lascar BAT 3V6 Non Rechargeable Battery for Data Loggers, 1/2 AA||
|EL-DATAPAD||Lascar EL-DataPad Handheld Programmer and Data Collector for EasyLog USB Range||
|EL-DATAPAD-BOOT||Lascar EL-DATAPAD-BOOT Protective Rubber Casing for EL-DataPad||