Phone 800-517-8431
Note: Image is Representative of Series;
Refer to Product Title for Model Specifications.

Keithley 2001/MEM1

7 1/2-digit High Performance Multimeter with GPIB Interface, 32K Memory

Brand: Keithley
Model No: 2001/MEM1
Our Model No: 2001MEM1
Condition: NEW
PDF Document Icon Data Sheet (324 KB)


Product Features:

  • True 7 1/2-digit resolution
  • 32K memory
  • Exceptional measurement integrity with high speed
  • High speed function and range changing
  • Broad range of built-in measurement functions
  • Multiple measurement display

The Keithley 2001/MEM1 7 1/2-Digit High-Performance Digital Multimeter w/32K Memory not only delivers performance specifications usually associated with instruments that cost thousands more, but it also offers a broad range of functions that are not typically available from DMMs.

True 7 1/2-Digit Resolution

The resolution specifications of the 2001/MEM1 are based on a 28-bit A/D converter that provides the resolution needed to discern smaller changes. This higher resolution also provides greater dynamic range, making it possible to measure from 1μV to 20V on a single range, thus avoiding range-shift errors and delays.

Built-In Scanner (Multiplexer) Options

With the addition of a plug-in scanner card, the 2001/MEM1 becomes a complete scan and measure system for applications involving up to ten measurement points.

High Accuracy ACV Measurements

A patented circuit design makes the 2001/MEM1 AC measurements several times more accurate than competitive DMMs. In this circuit, the signal bypasses the prime error-contributing section of conventional rms converters. This increases the accuracy at almost any voltage level, and also increases sensitivity down to a guaranteed 1% of the selected range, compared to 5–10% for most other DMMs. The result is highly accurate measurements over a broad range of inputs.

Applications involving vibration, servo, guidance, shock, and control systems often require accurate low frequency ACV measurements. The 2001/MEM1 maintains very good accuracy (better than 0.1%) down to 1Hz. The wide bandwidth of these DMMs allows for accurate measurements of high frequency AC signals without the need for a special AC meter. The 2001/MEM1 features TRMS AC, average AC, peak AC, AC+DC, and crest factor measurement capability for a wide variety of applications.

High Speed for High Throughput

In applications where high throughput is critical, the 2001/MEM1 provides more than 2000 readings per second at 4 1/2-digit resolution.

Fast, Flexible Triggering

Trigger latency - the delay between trigger and measurement - is often a barrier to higher throughput. Also, variability in latency can complicate predicting measurement timing. The 2001/MEM1 trigger is less than 2μs+/-1μs, which is much faster than typical system DMMs.

The unique Trigger-Link feature included in the Model 2001/MEM1 can be used to coordinate the operation of two or more instruments. Trigger-Link combines six independent software selectable trigger lines on a single connector for simple, direct control over all instruments in a system.

Spot Trends with the Bar-Graph Display

The ability to track reading trends around a target value easily can be just as important as the absolute readings. A unique bar-graph display function in the 2001/MEM1 indicates data as a percentage of the selected range from +/-0.01% to +/-100%. Whether adjusting about zero or any other desired value, this display can replace a nulling differential voltmeter.

Capture Spikes Down to 1μs

The 2001/MEM1 and has internal peak detectors that can catch 1μs spikes such as power supply spikes and transients, AC line power surges, and short-duration dropouts on components. These peak detectors operate up to 1 MHz for repetitive signals or down to 1μs for single spikes, so there is no need for a separate scope. The DMMs can automatically display and store the highest value or display the maximum and minimum values of spikes.

Built-in Features and Capabilities

The 2001/MEM1 offers many built-in measurements that are typically unavailable in instruments of this type, including in-circuit current, temperature with thermocouples or RTDs, and peak spikes. Four separate outputs linked to limits simplify configuring the DMMs for use in binning operations.

The built-in AC crest factor measurement helps ensure the accuracy of AC measurements. Other DMMs typically perform AC measurements for signals without excessive crest factor - the ratio of peak value to rms values. However, when crest factor rises, measurements may not meet specs. With a 2001/MEM1, there is no need for an oscilloscope to determine if the crest factor is acceptable - the DMM measures it directly.

While some DMMs calculate average AC from the rms value, these calculations apply only to sine wave inputs. The 2001/MEM1 measures peak value, average and true rms directly to obtain a complete characterization of the signal. This capability makes these DMMs ideal for AC circuit design or test applications and for verifying test voltages specified only in averages.

When measuring AC or digital signals, frequency is critical. The 2001/MEM1 accurately measures frequency up to 15 MHz. Accurate triggering on the signal is critical to measure frequency reliably. The frequency counters in the 2001/MEM1 have a fully adjustable trigger level for good measurements of noisy signals.

Multiple Measurement Display

The 2001/MEM1 can display DC and AC volts and the AC frequency from a single measurement connection simultaneously. Several other multiple-measurement displays are available, including crest factor and bar graph. By measuring sequentially and displaying simultaneously, the 2001/MEM1 operates as if three different meters are working together.

Option Slot Extends DMM Performance

An option slot in the back of the 2001/MEM1 opens the door to a wide range of measurement capabilities. Choose a 10-channel general-purpose scanner card or a 9-channel thermocouple scanner card to make measurements on multiple test points or devices. This can eliminate the need for a separate scanner and significantly reduce programming and setup time.

  • 1 - 7 1/2-Digit Multimeter w/Multichannel Scanning & Line Cord
  • 1 - MEM1 Option
  • 1 - High Performance Modular Test Leads (8605)
  • 1 - User Manual
  • 1 - Calibration Manual
  • 1 - Full Calibration Data (conforming to MIL-STD 45662A)
Model Description Buy Now Price
5805 Keithley 5805 .9m Kelvin Probes for Series 2400, Model 2750, and DMMs Add to Cart


5805-12 Keithley 5805-12 3.6m Kelvin Probes for Series 2400, Model 2750, and DMMs Add to Cart


5808 Keithley 5808 Single-Pin Kelvin Probes for Series 2400, Models 2700, 2701, and 2750, and DMMs Add to Cart


5809 Keithley 5809 Kelvin Clip Lead Set for Series 2400, Models 2700, 2701, and 2750, and DMMs Add to Cart


8605 Keithley 8605 High Performance Modular Test Leads for Series 2400 and DMMs Add to Cart


8606 Keithley 8606 High Performance Modular Probes for Series 2400 and 3700A, and DMMs Add to Cart


8610 Keithley 8610 Low Thermal Shorting Plug for Models 2000, 2001, 2002, and 2010 Add to Cart


8680 Keithley 8680 RTD Probe Adapter for Models 2001, 2002, 2010, and 2110 Add to Cart


8501-2 Keithley 8501-2 2m Micro-DIN-Male-to-Micro-DIN-Male Trigger Link Cable Add to Cart


8610 Keithley 8610 Low Thermal Shorting Plug for Models 2000, 2001, 2002, and 2010 Add to Cart


8620 Keithley 8620 4-Wire DMM Shorting Plug for Series 2400, Model 2750, and DMMs Add to Cart


4288-1 Keithley 4288-1 Single Fixed Rack Mount Kit Add to Cart


KPCI-488LPA Keithley KPCI-488LPA IEEE-488.2 Interface Module for PCI Buses Add to Cart


KUSB-488B Keithley KUSB-488B IEEE-488.2 USB-to-GPIB Interface Adapter for USB Ports Add to Cart


Gold Plans
Model Description Buy Now Price
2001/MEM1-3Y-EW Keithley 2001/MEM1-3Y-EW 3-Year Factory Warranty Extension for Model 2001/MEM1 Add to Cart


2001/MEM1-5YR-EW Keithley 2001/MEM1-5YR-EW 5-Year Factory Warranty Extension for Model 2001/MEM1 Add to Cart


2001/MEM1-EW Keithley 2001/MEM1-EW 1-Year Factory Warranty for Model 2001/MEM1 Add to Cart


Model Description Price
2001/MEM1-US Keithley 2001/MEM1-US *US Gov Edition* 7 1/2-digit High Performance Multimeter with GPIB, 32K Memory
GSA Advantage
GSA Contract GS-07F-0375T
Government-/GSA-Eligible Entities Only.
For GSA Price, Please Call
Direct: (339) 239-4066
See our GSA Listing
Datasheet: PDF Document Icon(324 KB)
Manual: PDF Document Icon(1.96 MB)
↑ Back to Top