| Specifications |
| Available Configurations |
HPNA testing, Physcial layer testing (coax
and twisted pair),Ethernet, Butt-Set, Wireless 802.11b/g WiFi |
| Physical Test Interfaces |
Coax F-connector for coax mapping, NIT, and
HPNA |
| RJ11 for POTS and HPNA testing |
| RJ11 for phone wiring and dry pair testing |
| RJ45 for Cat5/6 wiring and Ethernet testing |
| Connector LEDs for easy connector
identification |
| Standard Compliance |
ITU-T G.995.4 |
| Settings |
Configurable Host of Client mode |
| Configurable Band plan |
| Configurable IP settings |
| HPNA Network Results |
Segment specific rate, constellation, and
baud |
| Segment specific packet error rate (PER) |
| Segment specific SNR |
| Segment specific receive power |
| Cable ID |
Supports coax,Cat3/Cat5/Cat6 cable |
| Test via F-connector,RJ11,or RJ45 |
| Supports 8 ID devices on each interface |
| Toning |
Sends four types of tones on all leads:
-
Constant High pitch (976 Hz)
- Constant Low pitch (651 Hz)
- High pitch then a low pitch
- Low pitch with a short high
pitch |
| Coax Mapping |
Support any cable coax type with configurable
velocity ofpropagation (VOP) and cable compensation |
| Measures cable length in feet (up to 500 ft
at ±5 ft) |
| Measures return loss in dBrl (up to 20 dBrl
at ±2 dB) |
| Noise Immunity Test |
Test frequency of 88 to 108 MHz |
| Active identification |
IDs with up to 15 dB of signal loss between
unit and ID |
| Operating humidity |
10 to 80% RHNC |
| Temperature (Nominal range of use) |
–5 to +50°C (23 to +120°F) |
)
PDF Help