<< JDSU Fiber Identification Tools & Locator

JDSU FI-11
Fiber Identifier

Hand-held, lightweight, rugged, battery-powered
Interchangeable adapter heads for: jacketed, coated or ribbon fiber
Complete with carrying case
Attaches to belt or tool pouch
Operates with one hand
Operates from 800 nm to 1700 nm
Compatible with most AT&T and Corning optical fiber
Uses non-destructive macro-bending technology
Bidirectional traffic indication
High intensity LED indication of active signal transmission
Detects presence of 270 Hz, 1000 Hz and 2000 Hz modulated tones
Low-battery indication

JDSU Fi-11 Series
Shown

Product Information
Datasheet	581 KB
PDF Help

JDSU’s FI-11 hand-held optical fiber identifier probe is a rugged, easy-to-use installation and maintenance instrument which identifies optical fibers by detecting the optical signals being transmitted through a single mode fiber. By utilizing local detection technology (non-destructive macro-bend detection), it eliminates the need to open the fiber at the splice point for identification; eliminating the probability of interrupting service.

Signals detected include continuous wave (CW), live optical transmission, and low frequency modulated tones at 270, 1000 and 2000 Hz.

When traffic is present on the fiber tested, the direction of transmission is indicated by the JDSU FI11's LEDs illuminating on the probe. When modulated tones are present on the fiber under test, the unit will detect and illuminate the corresponding LED for 270, 1000 or 2000 Hz. The relative core power in the fiber is measured and displayed on a two-digit, seven-segment LED display.

This allows for the measurement of power loss through a splice or connector. The JDSU FI-11 has the widest environmental operating range of any optical fiber identifier on the mar-ket today.

Specifications
Optical Characteristics
Detection technique		non-destructive macro-bending
Typical Loss		<0.6 dB @ 1310 nm typical
Spectral Response		800 nm to 1700 nm
Detector Sensitivity		-40 dBm typical (equivalent core power)
Optical Tone receiver		270 Hz, 1 kHz, 2 kHz
Minimum Fiber slack		0.75 inches/19 mm required for detection
Core Power-Reading		0 to -40 dBm
Fiber Compatibility
Dual Window single mode		8 to 10 µm core diameter
Coating diameter		250 µm diameter
Coating		High refractive index acrylate
Electrical Characteristics
Power		one 9 V Alkaline battery
Operation		approx. 10,000 readings
Enviromental Conditions
Temperature	Operating	-20 to +50°C
	Storage	-40 to +60°C
Humidity		0 to 99% non-condensing

Ordering Information
Model	Description	Buy Online	Price
FI11	JDSU FI-11 Optical Fiber Identifier		Sale $1,783.95 (Reg. $1,880.00)

JDSU FI-11 Fiber Identifier

JDSU FI-11
Fiber Identifier