Innoventions RAMCHECK DIMMCHECK 144 Adapter

The new addition to the RAMCHECK line provides a needed solution for testing SDRAM and standard EDO/FPM DRAM 144-pin SO DIMM modules at an affordable price.

RAMCHECK automatically detects the presence of the RC 144 Adapter. The tester also automatically determines if the tested module is SDRAM or standard DRAM without the need for special setup.

In fact, you can test standard DRAM following an SDRAM, or vice versa, without the need of manual settings. Standard DRAM testing is similar to the regular EDO/FPM test procedure.

The RC 144 Adapter bursts complex pattern tests, into and from the tested module, at a true 133MHz (or faster) synchronous rate. The automatic test provides the tested module's size, voltage, frequency, and type. RAMCHECK's internal 184MHz test engine verifies that the tested module can accept the various mode commands, including CAS latency of 1, 2, and 3, sequential, or interleave type bursts at different lengths, and the single write mode. It further verifies interleaved bank operation.

Note: This adapter can be used only on RAMCHECK. It is not supported by our other generation of test equipment.

Required RAMCHECK Firmware Version: 2.05

RAMCHECK Adapters