IDEAL 33-881
LinkMaster Pro XL and ABS Deluxe Kit
Discontinued

• Back-lighted LCD screen
• Blinks the hub
• Increased voice testing capabilities
• Display length measurement with test results
• Remotes have RJ-11 and RJ-45 jacks
• Tests and identifies on all eight twisted pair and coax remotes
• Shows wiring errors
• Measures length
• Sends tone will four different signals
• Test results in wire map format
• Snap-off battery cap

62-180 ABS Tester Features:

• Economic alternative to the traditional butt set
• Allows for identification of dial tone problems, polarity certification, presence of power and tone tracing
• Speaker verified dial tone quality
• Ring indicator tests lines for correct number
• Polarity indicator tests for correct wiring and power
• Tone TRACE feature finds tracing tone signal
• Volume control switch
• RJ-11 jack access to wall outlets
• Two replacement line cords

Ideal 33-881 Shown

Product Information
62-180 Datasheet	74 KB
Manual	235 KB
PDF Help

Upon completion of the test, the wire map, ID and any faults are displayed.

• The top line of numbers on the display represents the connector pins on the main unit.
• The second line of pin numbers is the connector pin numbers of the remote.
• If there is a miswire, the numbers on the second line will indicate the pin numbers detected.
• If no connection was detected for some of the pins, the second line will be blank in those pin locations.
• If a short is detected, the second line will have a flashing ‘x' in that position, and the specific short condition displayed on the third line.
• If a split pair is detected, the pins affected will flash on the second display line. The specific split condition will be displayed on the third line.
• If there are multiple errors to display on the third line, the messages will be displayed in sequence until all are displayed.
• Under “ID”, the number of the remote being used will be displayed.