IDEAL FIBERTEK Premium
Advanced Fiber Test Options
(Singlemode and Multimode),
Discontinued
See: LanTEK II

• Measures signal loss length and delay over Singlemode fiber
• Enables bi-directional dual wavelength measurements for Singlemode fiber
• Talkset capability available for enhanced communications
• Premium kit also includes TRACETEK, IDEAL's advanced fault and event locator

Features for Multimode:

• Measures signal loss length and delay over Multimode fiber
  850 nm VCSEL light source enables Gigabit Ethernet certification on Multimode fiber
• Enables bi-directional dual wavelength measurements for Multimode fiber
• Talkset capability available for enhanced communications
• Premium kit also includes TRACETEK, IDEAL's advanced fault and event locator

Ideal Fibertek Shown

Product Information
Datasheet	370 KB
PDF Help

Using FIBERTEK adapters, the LANTEK display unit can measure length in the loop-back mode. Using FIBERTEK in both the display and remote units, the system can measure signal loss and length with dual wave-length and bi-directional capabilities.

To improve productivity, talkset capability is available for FIBERTEK. Simply plug in the talkset to the display and remote units, installers can communicate over fiber in the same fashion as over copper.

FIBERTEK supports network specific certification tests including 1000Base-LX and 1000Base-SX for Gigabit Ethernet. This allows the installer to easily certify fiber for the most common network types. All fiber tests are stored in the same way as copper tests and can be uploaded to a PC running LANTEK Reporter to create reports.