TREND Networks SignalTEK NT

SignalTEK NT 1GB Network Cable Transmission Tester

R156003
SignalTEK NT

TREND Networks SignalTEK NT

SignalTEK NT 1GB Network Cable Transmission Tester

R156003
SignalTEK NT
  • Test network traffic performance on copper and fibre to IEEE802.3ab standards
  • Wiremap test for opens, shorts, miswires, and split pairs to TIA-568 standards
  • Gigabit link verification for copper and fibre cabling
Replaced with:
TREND Networks R156005 SignalTEK NT Copper and Fiber Network Transmission Tester
TREND Networks SignalTEK NT
SignalTEK NT Copper and Fiber Network Transmission Tester
  • Test network traffic performance on copper and fibre to IEEE802.3ab standards
  • Wiremap test for opens, shorts, miswires, and split pairs to TIA-568 standards
  • Gigabit link verification for copper and fibre cabling
  • Test Network loads through switches to simulate CCTV/IPTV/VoIP/Web traffic
  • PoE/PoE+ verification that displays available voltage at device location
  • Check Ethernet connectivity at device location to 10/100/1000 Mb/s
  • Verify network configuration (device IP/gateway address/subnet mask)
  • Switch port identifications via LLDP/CDP protocols
  • Measure distance to fault using TDR technology (copper only)
  • Identify and trace cables w/compatible amplifier probes
  • Optical power indication (w/compatible SFP modules)
  • Stress test networks before installing bandwidth-intensive devices
  • Port blink to visually trace cable from work area outlet to network switch
  • Displays port ID of LLDP/CDP enabled switches to eliminate manual cable tracing
  • Identify network connection problems, such as hardware, network, or configuration faults
  • Ping local network devices and Internet URL’s
  • Count number of hops between network points w/traceroute testing
  • PoE load tests confirm available power meets PoE device requirements

The IDEAL Networks R156003 SignalTEK NT 1GB Network Cable Transmission Tester tests the performance of voice, data, video and CCTV applications on 10/100/1000 Mb/s Ethernet networks; it issues a report to prove installed data cables or networks can carry Ethernet traffic at full speed, without packet errors.

The R156003 utilizes a method known as transmission testing to prove the performance of a network by sending real Ethernet data frames through the cabling and/or network devices, then comparing the received data with the transmitted data to determine the error rate. This network "stress test" method generates reports of real-world 1000Base-T performance to the IEEE 802.3ab gigabit Ethernet standard. When connected to an active network, the SignalTEK NT also uses CDP and LLDP to display the MAC address.

SignaTEK NT supports the new IDEAL AnyWARE mobile app, which wirelessly connects and transfers reports from the tester to any mobile device. Once data is transferred, PDF and CSV reports can be viewed on the device and sent using email or supported Internet file-sharing services.

More Information
Country of OriginMalaysia
BrandTREND Networks
ConditionNEW
UPC783250773176
Vendor AliasR156003
  • 1 - SignalTEK NT Display Unit
  • 1 - Remote
  • 2 - NiMH Batteries
  • 2 - 30cm Cat 5e STP Patch Cables
  • 2 - Power Supplies w/EU/UK/US Adapters
  • 1 - USB Wi-Fi Adapter
  • 1 - User Manual
  • 1 - Carry Case