This site uses cookies to provide an optimized shopping experience. By using this site, you agree the use of cookies within our privacy policy.
Hioki PW3198-01/5000 PRO
Power Quality Analyzer Kit with three 5000 AAC Clamp on Sensors
Hioki PW3198-01/5000 PRO
Power Quality Analyzer Kit with three 5000 AAC Clamp on Sensors
- Power Analyzer kit with three 5000 AAC Clamp on Sensors included
- Verify power problems in accordance with the IEC61000-4-30 Class A standard
- High Accuracy and continuous gapless recording
- Power Analyzer kit with three 5000 AAC Clamp on Sensors included
- Verify power problems in accordance with the IEC61000-4-30 Class A standard
- High Accuracy and continuous gapless recording
- CAT IV 600V - safe enough for incoming power lines
- Broadband voltage range lets you measure even high-order harmonic components of up to 80 kHz
- Wide dynamic range from low voltages up to 1300V (3P4W line-to-line voltage)
- Maximum 6000V transient overvoltage up to 700kHz
- International power quality measurement standard IEC 61000-4-30 Edition 2 Class A
- LAN, USB and SD card interfaces
- Current sensors are necessary to measure current or power parameters
- 5000 AAC Clamp sensors:
- 1 sensor necessary for single-phase measurements, and 2 or 3 sensors required for 3 phase measurements
- 10 Hz to 20 kHz (+/- 3dB)
- 5000 A/ 500 A AC rated input
- 500 mV/f.s. output
The Hioki 3198-01/5000PRO is a power quality analyzer kit for monitoring and recording power supply anomalies, allowing their causes to be quickly investigated, and also for assessing power supply problems such as voltage drops, flicker, harmonics, and other electrical issues.
The number of power supply problems is increasing as power systems are becoming more and more complicated - all due to the rising use of power electronics devices plus a growing installed base of large systems and distributed power supplies. The quickest way to approach these problems is to understand the situation quickly and accurately. The 3198-01/5000PRO Power Quality Analyzer is ready to effectively solve your power supply problems. The kit inlcudes three 1000A AC voltage output clamp sensor for measuring large load current.
Country of Origin | Japan |
---|---|
Brand | Hioki |
Condition | NEW |
Vendor Alias | PW3198-01/5000 PRO |
- 3 - CT9667 5000 AAC Clamp on Sensors
- 1 - Instruction manual
- 1 - Measurement guide
- 1 - Set Voltage cord L1000
- 8 - Alligator clip
- 20 - Spiral tube
- 1 - Input Cable Labels
- 1 - AC adapter Z1002
- 1 - Strap
- 1 - USB cable (1 m 3.28 ft length)
- 1 - Battery pack Z1003
- 1 - SD memory card 2GB Z4001
- 1 - Software 9624-50