Test Equipment Depot - 800.517.8431

Test Equipment Catalog Specials  Repair Surplus Ordering/Contact Info

 

Hamlet Video Test Equipment
Hamlet Catalog | Price List

 

<< Hamlet Waveform Monitors Index

Hamlet 300W Pico Scope
Portable Composite Waveform Monitor

  • Input: 1 Composite with Loop
  • Output: 1 Composite picture and trace
  • Displays, inserted, mixed with input or on black
  • Full screen or monitoring size top or bottom of frame
  • NTSC or PAL operation
  • Active level shot to shot comparison cursor
  • Flat, Low pass and Chroma pass Filters
  • Powered by 2 x Standard AA cells, or 12VDC mains adapter included.

Click here for larger image - Hamlet 300W Pico Scope Portable Composite Waveform MonitorClick here for larger image - Hamlet 300W Pico Scope Portable Composite Waveform Monitor
Hamlet 300W Shown
 

Product Information
Datasheet 155 KB
Ordering Info Jump to Product Models, Prices, Accessories, and Ordering Information
PDF Help
 

The Hamlet 300W Pico Scope is the smallest portable composite waveform monitor unit in the world. Since the unit is powered by 2 x AA battery cells or via its 12Vdc adapter (included), it can be taken on the job or moved from place to place with very little hassle. The display is used to show the results of a 1H trace of Active Video or with Synchronization and Burst components. The monitor only weighs in at 415grams (14.5 oz), and is available in two formats; PAL or NTSC. 

 
Specifications Description
Display area The waveforms are in boxes burnt into the video signal.
Small modes: Box is 128 lines high, with a width of 14uSec.
Expand mode: Box is 512 lines high, with a width of 42uSec.
Signal Connection Inputs: BNC connector with loop-through output. Return loss is better .than 40db. Input impedance 15K ohm,max d.c.+/- 10 volts.
Output: Output to monitor is 1 Volt to 75 ohms.
Option: The Pico Scope can be factory set such that on power-down, the unit is bypassed so that the output is directly connected to the input, and the loop output is disconnected.
Specification Response: FLAT is +/- 1% from 25Hz to 5.5MHz, -5% at 10MHz.
LPASS is a low pass filter -1db at 1MHz, -40db at 3.58 / 4.4MHz.
CPASS is a band pass filter -3db at +/- 750KHz.
Sensitivity: Black level displays 0%, white level displays 100%.
Calibrator: Error in CAL position is less than 1% (0.007V). Calibration line variable over full signal range.
D.C. Restorer: Attenuation of less than 30% to line hum signals.
Display level change less than 2% for 1 volt change in signal level.
Power NT: 2 x 1.5V AA cells, life approx 4 hours (Lithium).
1.5 hours (Alkaline) or 1 hour (Nicad).
EXT: 8V-15V D.C. at 0.21 amp. Centre neg 2.1mm skt.
Temperature 0 to 45 degree Celsius. Ambient to 10,000 ft.
Environment Indoor use, 5 to 45 deg.C. Ambient to 2,000m.
Max humidity 80% to 31 degrees Celsius decreasing to 50% at 40 degrees Celsius.
Overvoltage category 2
Pollution degree 1
Dimensions 5.9" x 5.1" x 1.9" Inches
(150 x 130 x 50 mm)
Weight Without Batteries 1.7 Lbs. (750g)
With Batteries 1.94 Lbs. (880g)
 
Ordering Information
Model Description Buy Online Price
300WPAL Hamlet 300W PAL Stanard Picoscope Portable composite waveform display unit  Buy Now $1,900.00
300WNTSC Hamlet 300W NTSC Stanard Picoscope Portable composite waveform display unit  Buy Now $1,255.00
 
Hamlet Catalog   |   Hamlet Price List

$20.00 Minimum on Total Order

Home Page | Test Equipment Catalog | Specials | Repair
We Buy Surplus | Ordering/Contact Info
____________________________________________________________

99 Washington Street, Melrose, MA 02176
781.665.1400 | 800.517.8431 | Fax: 781.665.0780 | Email:

Copyright © Fotronic Corporation All Rights Reserved