Fluke Current Clamp Meters

Type of Meter	Images	Uses	Fluke Products
AC/DC Current Clamp Meters		AC Amps DC Amps (select Models) Ohms AC Volts DC Volts (select Models) Auto-Off / Hold Great for: Industrial Plant Maintenance Commercial work Electricians	Fluke 320 Series
			Fluke 330 Series
			Fluke 353
			Fluke 355
			Charts
Power Quality Clamp Meter		Setup and troubleshoot variable frequency drives and UPS systems Harmonics measurements Inrush capture Load studies Great for: Environmental usage Plant Maintenance Electricians	Fluke 345
HVAC Compliant		Capture flue gas temperatures Conduct flame rod testing Measure start and run motor capacitors Measure supply side current and voltage as well as load side current and voltage Measure current and voltage phase balance on 3 phase systems Troubleshoot compressor electrical motor faults Great for: Commercial Electricians	Fluke 902
Process Clamp Meter		Measure mA signal for PLC and control system analog I/O Measure 4 to 20 mA output signals from transmitters without breaking the loop. Measure mA signals with 0.01 mA resolution Great for: Plant Maintenance Electricians	Fluke 771
Milliamp Process Clamp Meter		Source 4 to 20 mA signals for testing control system I/O or I/Ps Simulate 4 to 20 mA signals for testing control system I/O Measure 4 to 20 mA signals with in-circuit measurement Simultaneously measure mA in-circuit with 24 V loop power for powering and testing transmitters Source mA output signals in a linear ramp or 25 % step output– Automatically change the 4 to 20 mA output for remote testing Great for: Plant Maintenance Electricians	Fluke 772
Milliamp Process Clamp Meter		DC voltage measurement to verify 24 V power supplies or voltage I/O signals Source DC voltage to test input devices that accept a 1 to 5 volt or 0 to 10 volt signal Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp Output mA signal enables a logging DMM or other device to record the 4 to 20 mA signal without breaking the loop mA in/out: simultaneously measure the mA signal with the clamp and source a mA signal Apply a mA input signal to a device and measure its 4 to 20 mA output on devices such as valves or mA isolators Voltage output linear ramp or 25% step output Automatically change the voltage output for remote testing Great for: Plant Maintenance Electricians	Fluke 773

See Also: DMM and ScopeMeter Accessory Clamp Meters