| Specifications |
| Electrical Characteristics |
| Measurement Range |
100 to 5000 A (with a crest factor ≤3) |
| Frequency Range |
40 Hz to 5 kHz |
| Accuracy (@ 25°C) |
±1% of reading |
Linearity
(10 % to 100 % of range) |
±0.2% of reading per °C |
| Temperature Coefficient |
±0.05% of reading per °C |
Position Sensitivity
(w/ cable >25 mm from coupling) |
±2% of reading |
External Field
(w/ cable >200 mm from head) |
±1% of reading |
Working Voltage
(see Safety Standards) |
1000V ac rms or dc |
| General Characteristics |
| Probe and Cable Material |
Alcryn 2070NC, reinforced insulation, UL94 V0, Color: RED |
| Probe Cable Length |
48 in. (610 mm) |
| Probe Cable Diameter |
0.3 in. (8 mm) |
| Transducer Bend Radius (min) |
1.5 in. (38.1 mm) |
| Output Cable |
2 core screened, double insulated, 3 meters long |
| Output Connector |
LEMO 6 pin male connector |
| Operating Temperature Range |
-4 to +158°F (-20 to +70°C) (the temperature of the conductor under test shall not exceed 176°F /80°C) |
| Storage Temperature Range |
-40 to 176°F (-40 to +80°C) |
| Operating Humidity |
15% to 85% (non condensing) |
| Altitude |
max 6562 ft. (2000 m) |
| Degree of ingress protection |
IP40 (IEC 60529) |
| Safety Standards |
EN/IEC 61010-1:2001
EN/IEC 61010-031:2002+A1:2008
EN/IEC 61010-2-032:2002
Pollution Degree 2
Use of the Probe on uninsulated conductors is limited to 1000 V under CAT III installations and 600 V under CAT IV installations ac rms or dc and frequencies below 1 kHz.
Note that the safety rating for the output to ground is limited to 30 V ac rms or dc by the connector specified. |
)
PDF Help