|
<< Amprobe Digital AC Clamp Meters
Amprobe ACD-10 Plus and ACD-10 TRMS Plus
Digital Clamp - On Multimeter
|
- AC & DC Voltage to 600V
- AC Current to 600A
- Thin Jaws, only 10mm (0.4”) thick
- Resistance to 40M
- W Continuity Buzzer
- Capacitance to 3000 uF
- Frequency measurement
- In rush current
- Hold & Maximum reading functions
- Accommodates conductors up to 26mm (1.02”) in diameter
- Auto ranging
- Auto power off
- Rubber over-molded case
- Overload protected
|
 
Amprobe ACD-10 Plus
Shown
|
The Amprobe ACD-10 Plus and ACD-10 TRMS Plus provides the user with the same level of
performance as it's predecessor, the Amprobe ACD-10-Pro, but provides
optimum performance as well as enhanced features
|
|
Electrical Specification Accuracy
(23 °C ± 5 °C & < 75% R.H.) |
|
|
Range |
Accuracy |
|
DC Voltage |
General Stats |
400.0 mV |
±( 0.3% + 4 digits) |
|
4.000, 40.00, 400.0 V |
±( 0.5% + 3 digits) |
|
600V |
±( 1.0% + 4 digits) |
|
NMRR |
>50 dB @ 50/60Hz |
|
CMRR |
>120 dB @ DC, 50/60 Hz, Rs=1 kW |
|
Input Impedance |
10 MW, 30 pF nominal (1000 MW for 400.0
mV range) |
|
Transient protection |
6.5 kV (1.2/50 μs surge) |
AC Voltage
(50Hz ~ 500 Hz) |
Range/Accuracy |
4.000, 40.00, 400.0 V |
±( 1.5% + 5 digits) |
|
600V |
±( 2.0% + 5 digits) |
|
CMRR |
>60dB @ DC to 60 Hz, Rs=1 kW |
|
Maximum Crest Factor |
< 1.75 : 1 at full scale & < 3.5 : 1 at half scale
limited to fundamental and harmonics, that fall within the meter
specified AC bandwidth for non-sinusoidal waveforms |
|
Input Impedance |
10 MW, 30 pF nominal |
|
Transient protection |
6.5 kV (1.2/50μs surge) |
|
AC Current |
General Stats |
40.00, 400.0, 600A |
±( 1.5% + 8 digits)(See
Notes) |
|
Additional Notes |
-
Max Induced error from adjacent
current carrying conductor: 0.05 A
-
Specified accuracy is from 1% to
100% of range and for measurements made at the jaw center. When
the conductor is not positioned at the jaw center, position
errors introduced are: Add 2% to specified accuracy for
measurements made BEYOND jaw marking lines (toward jaw opening)
-
Add 8 digits to specified
accuracy @ reading < 10% of range
|
|
Overload Protections |
ACA Clamp-on jaws : 600 A rms continuous |
|
Sensing Levels |
ACD-10 Plus |
Average Sensing |
|
ACD-10 TRMS-Plus |
True RMS sensing: 10% to 100% of range |
|
Resistance |
General Specifications |
400.0 Ω |
±( 0.8% + 8 digits) |
|
4.000, 40.00, 400.0 kΩ |
±( 0.6% + 4 digits) |
|
4.000 MΩ |
±( 1.0% + 4 digits) |
|
40.00 MΩ |
±( 2.0% + 4 digits) |
|
Open Circuit Voltage |
0.4 VDC typical |
|
Transient protection |
6.5 kV (1.2/50μs surge) |
|
Power Consumption |
AC drive: 10 VA maximum, DC drive: 5 W maximum |
|
|
|
Function |
Sensitivity (Sine RMS) |
Range |
Accuracy |
|
Frequency |
General Specifications |
400.0 mVac |
350mV 1 |
0 Hz ~ 2 kHz |
±( 0.5%+4 digits) |
|
4.000 Vac |
1V |
5 Hz ~ 5Khz |
|
4.000, 40.00 Vac |
32V |
5 Hz ~ 100 kHz |
|
400.0 Vac |
90V |
5 Hz ~ 10 kHz |
|
600 Vac |
500V |
5 Hz ~ 5kHz |
|
400.0 Aac |
60A |
40 Hz ~400 Hz |
|
Display counts |
5000 |
|
Resolution |
0.001Hz |
|
Overload Protection |
ACA Clamp-on jaws : AC 600A rms continuous |
|
Transient protection |
VAC input jacks : 6.5kV (1.2/50μs surge) |
|
Power Consumption |
AC drive: 10 VA maximum, DC drive: 5 W maximum |
|
Capacitance |
Range |
500.0nF, 5.000μF, |
Additional 50.00nF range accuracy is not specified
|
|
50.00μF, 500.0μF, 3000μF |
|
Accuracy |
±( 3.5% + 6 digits) |
Accuracies with film capacitor or better
Specified with battery voltage above 2.8V (approximately half full
battery). Accuracy decreases gradually to 12% at low battery warning
voltage of approximately 2.4V |
|
Transient protection |
6.5 kV (1.2/50 μs surge) |
|
Audible Continuity Tester |
Audible indication |
between 10 W and 120 W. |
|
Transient protection |
6.5 kV (1.2/50 μs surge) |
|
Diode Tester / Open Circuit Voltage Test Current |
(typical) |
< 1.6 VDC @ 0.25 mA |
|
Transient protection |
6.5 kV (1.2/50 μs surge) |
|
Max Hold (where applicable) |
Specified accuracy ± 50 digits for changes > 25 ms in
duration |
|
|
|
|
|
| Ordering Information |
| Model |
Description |
Buy Online |
List Price |
| ACD10PLUS |
Amprobe ACD-10 PLUS Digital Clamp-on Multimeter |
 |
$94.95 |
| ACD10TRMSPLUS |
Amprobe ACD-10 TRMS-Plus 600A Clamp-on Multimeter |
|
$114.95 |
| Included Accessories |
| |
- 1 - Users manual
- 1 - Battery (pre-installed)
- 1 - Test Lead
- 1 - Soft Carrying Pouch
|
Included |
|
)
PDF
Help