<< Psiber LanMaster SeriesPsiber LanMaster
35
Power and Link Tester
|
-
Tests network cable pairs for Power over Ethernet (PoE)
-
Identifies the power type as IEEE 802.3af, Cisco
Inline or Non-Standard
-
Makes power measurements with loads simulating actual
powered devices
-
Displays voltage and polarity for wire pairs and
power configuration as End-span, Mid-span or All-span
-
Identifies damaged cables and bad punchdowns by
measuring Link Resistance
-
Detects 10/100/1000 BaseTX Link speed and duplex mode
-
Measures cable length and open or short conditions
-
Provides Port ID function (link light activation) for
identifying connected ports
-
Applies a tone signal for tracing cables with the
CT15 CableTracker Tone Probe
|
 
|
|
|
The new LanMaster 35 Power and Link Tester is the first full featured PoE
(Power over Ethernet) and 10/100/1000BaseTX Link tester. The LanMaster
35 features PoE measurement with actual loads to verify required power
is available before connecting a powered device such as a VoIP phone or
wireless access point. The unit identifies the power configuration as
End-span, Mid-span or All-span and the type of power as IEEE 802.3af,
Cisco Pre-Standard or Non-Standard. A Link resistance measurement
feature helps to identify cabling problems. The LanMaster 35 also tests
10/100/1000 BaseTX Links providing the speed and duplex mode for the
Link. In addition, the tester includes Tone Generation for cable
tracing, TDR length measurement, and Port Identification to provide a
complete suite of LAN test functions.
The LanMaster 35 provides essential PoE and Link testing capabilities in
a low cost handheld tester. The optional CableTracker 15 Tone Tracing
Probe works with the LanMaster 35 Tone Generator feature to trace cables
or locate connected punchdowns.
|
|
|
)
PDF Help