| Specifications AEMC MTX1054 |
| Interface |
| Screen Specifications |
Color PC screen (min. resolution: 1024 x 768) |
| Display Mode |
8 x 10 div.- Multi-windowing (control panel, trace, zoom, FFT, etc.) |
| No of Traces on Screen |
Four traces and four references |
| Screen Control |
"Windows-like" and online help – all commands available via mouse |
| Vertical |
| Vertical Sensitivity |
2.5mV – 100V/div, up to 250μV/div with vertical expansion |
| Bandwidth |
150MHz (bandwidth limiter: 15MHz, 1.5MHz or 5kHz) |
| Channels |
4 channels, class 1, common ground |
| Horizontal |
| Time Base Speed |
32 ranges from 1ns to 200s/div |
| Trigger |
| Mode |
Auto, Triggered, One-shot ROLL, auto-level at 50% |
| Source |
CH1-CH4, Mains |
| Type |
Edge, Pulse Width or Delay (40ns - 10.5s), counting (2 - 16,384 events), TV (525 = NTSC, 625 = PAL/SECAM), Pre-trigger adjustable from 0 to 100%, Hold-off (40ns - 10.5s) |
| Digital Memory |
| Max. Sampling Speed |
Repetitive = 100GS/s One-shot = 200MS/s |
| Vertical Resolution |
10 bits (9 bits used) |
| Memory Capacity |
Depth = 50,000 points – storage capacity depends on PC configuration used |
| SPO (Smart Persistence Oscilloscope) |
| Duration of Persistence |
100ms, 200ms, 500ms, 1s, 2s, 5s, 10s and infinite |
| Performance |
Acquisition rate 50 kwaveforms/s/channel, no. of samples acquired: 19MS/s/channel |
| Measurement Processing |
| FT Analyzer/Math Functions |
FFT (calculation over 2,048 points), + , - , x , / – "Made-to-measure" function editor |
| Manual Cursors |
dv, dt, 1/dt, phase – cursors linked or unlinked to trace |
| Automatic Measurement |
2 or 19 measurements out of 19 + automatic phase On-any type of curve Markers and limits |
| Recorder Mode |
| Duration/Sampling |
Duration: 2s to 31 days / Sampling interval: 40μs to 53.57s |
| Harmonic Analyzer |
| Analysis Range |
Fundamental from 40Hz to 1kHz + 31 orders on 1 to 4 channels |
| Processing |
Total RMS value, THD and selected order (%F, phase , frequency, VRMS) |
)
PDF Help