This site uses cookies to provide an optimized shopping experience. By using this site, you agree the use of cookies within our privacy policy.
AEMC MR6292
DC Current Probe, 50A DC for use only with Model 6292
MR6292
MR6292
The AEMC MR6292 AC/DC Current Probe is compatible with AEMC 6292 Micro-Ohmmeters and required to take measurements in BSG mode. The probe has a proportional mV output for direct reading on the 6292.
- Measurement Range: 1 to 50ADC
- Accuracy: 1 to 50ADC: 1.5% reading ± 0.2A
- Output Signal: 10mV/ADC
- Load Impedance: >100kΩ/100pF
- Insertion Impedance: 0.39mΩ @ 50Hz, 58mΩ @1000Hz
- Working Voltage: 600Vrms
- Measurement Range: 1 to 50ADC
- Accuracy: 1 to 50ADC: 1.5% reading ± 0.2A
- Output Signal: 10mV/ADC
- Load Impedance: >100kΩ/100pF
- Insertion Impedance: 0.39mΩ @ 50Hz, 58mΩ @1000Hz
- Working Voltage: 600Vrms
- Influence of Adjacent Conductor: < 10mA/A at 50Hz at 23mm from probe
- Influence of Conductor in Jaw Opening: 0.5% reading
- Power Source: Powered by Micro-Ohmmeter Model 6292
- Jaw Opening: 1.2" (31mm)
- Maximum Cable Diameter: One 1.18" (30mm) or two 0.95” (24mm) or two bus bars 1.2 x 0.4" (31.5 x 10mm)
- Dimensions: 8.8 x 3.82 x 1.73" (224 x 97 x 44mm)
- Weight: 15 oz (440g)
- Output: 4-conductor shielded cable with 5-pin XLR connector
- EN 61010-2-32, 600V CAT III, Pollution: 2
The AEMC AC/DC Current Probe Model MR6292 is an accessory for the Micro-Ohmmeter Model 6292. The Model MR6292 probe is required for using the Model 6292 to take measurements in BSG (both sides grounded) mode. The probe has a proportional mV output for direct reading on the Model 6292.
Country of Origin | United States |
---|---|
Brand | AEMC |
Condition | NEW |