<< AEMC Clamp-On Resistance Testers
|
AEMC 3731
Clamp-On Ground Resistance Tester |
- Simple and fast clamp-on operation - no leads, no auxiliary rods or spacing requirements. No need to disconnect neutral service
- Direct reading of ground resistance from 0.1 Ohm to 1200 Ohms
- Direct reading of continuity and ground loop resistance
- Direct reading of ground leakage current from 1 mA to 30 Amps rms
- Large 1.38" Jaw opening
- Auto-off
- Adjustable Alarm Set-point
- Store 99 field measurements in memory for later retrieval and analysis
|
 
AEMC 3731 Shown
|
|
|
|
Applications
- Measures ground rod and small grid resistance.
- Use in multi-grounded systems without disconnecting the ground under test.
- Measure resistance and continuity of grounding loops around pads and buildings.
- Measure leakage current flowing to ground or circulating in ground loops.
- Conduct quick field checks.
- Conduct field surveys and retrieve and analyze readings are a later time.
|
| |
Check Resistance on Single and Multiple Rods or Grids
Clamp-on Ground Resistance Testers are used in multi-grounded systems
without disconnecting the ground under test. The Model 3731 simply
clamps around the ground conductor or rod and measures the resistance to
ground. By performing measurements on intact ground systems, the user
also verifies the quality of the grounding connections and bonds.
Resistance and continuity of grounding loops around pads and buildings
may also be measured. |
| |
)
PDF Help