<< AEMC FlexProbe Flexible Current ProbesAEMC 24-2000
FlexProbe Flexible Current Probes,
Discontinued
- 24" flexible sensors fits
around conductors up to 8" in diameter
- Dual measurement ranges of 200A and
2000A
- Read amperage directly on DMM
display
- mV output directly proportional to
the AC current measured
- Output is 10mV/A on 200A range and
1mV/A on 2000A range
- Accuracy of 1% of Reading
- Less than o.5% influence of
conductor position in jaw
- 720 hour (1 month) battery life
- Dual banana plug termination for
direct input into DMMs
- Optional dual banana to BNC adapter
for use with oscilloscopes
- Flashing LED low battery indicator
- IEC 1010, 1000V, Cat. III
The FlexProbe™ is a flexible AC current transformer composed of a flexible
sensor and an electronic module. The flexible sensor permits measurements on
conductors where standard clamp-on probes could not be used. In particular, it
can be installed in tight spaces, around breaker panels, around cable bundles,
around wide or large bus bars, or even wrapped around irregular shapes. The
Shape Memory feature enables the user to pre-shape the sensor, somewhat, before
inserting it between or around conductors. This feature facilitates closing,
enhances user safety, and alleviates the drooping effect typically associated
with flexible sensors. The FlexProbe™ is lightweight. It has an mV output
proportional to the current measured for direct readings on DMMs, data loggers
and oscilloscopes. TRMS measurements are taken when connected to a TRMS meter.
The The FlexProbe™ is insensitive to DC currents an only the AC component of
the measured signal is measured.
|
