<< AEMC Cable Testers
|
AEMC CA7028
Wire Mapper Pro LAN, Wiring and Cable Tester |
- Indicates all common wiring faults including split pairs, shorts, opens, reversed pairs and crossed wires
- Unique graphical and digital display of fault information and length
- Indicates distances to opens and shorts and identifies locations
- Built-in tone generator for tracing and locating cables
- Built-in service check function to detect telephone, 10BaseT, 100Mbit+ and token ring
- Visual and audible warning of live telephone network voltages
- Works with all Category 6 cables
- Large high-visibility blue electroluminescent backlit display
- Active remote identifiers indicate Pass/Fail at remote end
- Up to 16 unique remote identifiers available
- Works with TIA 568A/B, USOC and ISDN wiring schemes
- CE Mark
|
 
AEMC CA7028 Shown
|
|
|
| |
The Wire Mapper Pro Model CA7028 is a
hand-held structured cable mapping and troubleshooting tester designed
for use on UTP, STP, FTP and SSTP cabling equipped with RJ-45 connectors
and wired to either TIA 568A/B (ISO 11801 and EN 50137), USOC or ISDN
specifications. It detects open circuit pairs, shorts, crossed wires,
crossed pairs, reversed pairs, split pairs and shield faults.
The Model CA7028 has the ability to measure and indicate the length of the
cable under test, using a Vp (Velocity of Propagation) set by the user,
from a built-in library or manually. It will measure and report the
length of all four pairs of wires in the cable under test. It also
generates an audible tone that is transmitted into all four pairs on the
cable under test. |
| |
)
PDF Help